• national passports;
• internal passport of the Russian Federation;
• ID cards
The system may fail to recognize a document for the following reasons:
• poor lighting, glare, shadows, or external light sources;
• a blurred image or a dirty device camera;
• the document does not fully fit into the frame;
• an attempt to scan a photo from a screen, a screenshot, or a copy instead of the original;
• a damaged or heavily worn document;
• the document type does not meet the system requirements;
• technical limitations of the device or low camera quality;
• a missing or malfunctioning RFID/NFC chip in the document (if the document supports electronic reading).
Please contact technical support. Specify:
• the email used during registration;
• that the number of attempts is zero;
• attach a screenshot of the notification.
Document scanning instructions:
• First, scan the first page of the document where your personal data is shown.
• Keep the document inside the camera frame and wait until the frame turns green.
• After the animation appears, scan the page with the signature (the top page), or the back side of the document if you have an ID card.
• After the passport is scanned, the app will automatically offer the chip reading (RFID) step if the document contains a chip and your phone has an NFC module. If the document has no chip or the device does not support NFC, the app will automatically redirect you to the next step.
• After a successful scan, the app will automatically redirect you to the video verification (liveness) step.
Please make sure the document is well lit, not covered by your fingers, and fully fits inside the camera frame.
To verify the authenticity of a biometric document and automatically retrieve the data from the electronic chip of the passport.
We recommend the following steps:
1. Turn on NFC in your phone settings.
2. Remove the case/cover and use the original document.
3. Find the chip area:
• passport with a polycarbonate photo page → place the phone on the photo page;
• passport with a paper photo page → place the phone on the cover (the chip is usually in the front or back cover).
If unsure, slowly move the phone across the back of the document.
4. Hold still for a few seconds without moving the phone or the document.
5. Still not working? Restart the app and try again; try another NFC-enabled device.
If the problem persists — the chip may be damaged or demagnetized.
In biometric international passports (with an electronic carrier), the chip is embedded inside the cover of the document. It is usually located:
• either in the front cover;
• or in the back cover (less often — it depends on the passport series).
It is not visible, but the cover has a special symbol (a chip icon — a rectangle with a circle) indicating that there is an RFID chip inside.
If the document has no chip or your phone does not support NFC, the app will automatically redirect you to the next step.
Contact technical support and provide the following information:
1. Your full name in English.
2. Document number.
Our specialists will check the information and provide the details of the account the document is linked to.
This means that this document has already been added to another QazETA account — for example, if someone else (an intermediary, travel agent, or service assistant) completed the registration earlier. Each document can be linked to only one account.